At one point when the video mentions that the dump hasnt been flipped, what program does he open up the file in? And where can it be gotten?
Thank you
VOLVO CEM VIDEO QUESTION
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Re: VOLVO CEM VIDEO QUESTION
The software read the ECU properly. If you have the programmer read it is flipped. The command "hilo" can help you flip the byte order.
Re: VOLVO CEM VIDEO QUESTION
Ok and a couple other question. At one point I read a dump but it didn’t show under control it showed under EEPROM? But in the video the tab shows FLASH? Is this just a change in software versions? Because control showed all F’s.
Also I noticed when it says move the 2 script files there is one norflash and the volvocem xml where can one obtain the 2 files?
And lastly even after connecting all the wires and the 12V power supply it always says BDM OFF in bottom right hand corner. How do you make this come on?
Also I noticed when it says move the 2 script files there is one norflash and the volvocem xml where can one obtain the 2 files?
And lastly even after connecting all the wires and the 12V power supply it always says BDM OFF in bottom right hand corner. How do you make this come on?
Who is online
Users browsing this forum: No registered users and 4 guests