s25fl256 flash ic

Here we discuss the JTAG on platforms. CPU,CPLD etc.
Junior Member
Posts: 8846
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

Finally I found why NT cannot erase the flash. It is related to the power supply of NT (I am using power from NT).
If I connect a 12ohm resistor from power on NT to the VCC on the flash, I can erase the flash without any issue.
I looked at the datasheet, when erase a flash it might draw max 100mA from the power. Without resistor, I think the power to the flash is not stable.
Anyway, no need to release another version to program this chip.
Simple solution is to use a small resistor. I even put a multi meter between (20 am current) and it also works.
I found only need to use it when erase. When program it is not needed.

Final working resistor value for erase and write is 6ohm.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest