Finally I found why NT cannot erase the flash. It is related to the power supply of NT (I am using power from NT).
If I connect a 12ohm resistor from power on NT to the VCC on the flash, I can erase the flash without any issue.
I looked at the datasheet, when erase a flash it might draw max 100mA from the power. Without resistor, I think the power to the flash is not stable.
Anyway, no need to release another version to program this chip.
Simple solution is to use a small resistor. I even put a multi meter between (20 am current) and it also works.
I found only need to use it when erase. When program it is not needed.
[Edit]
Final working resistor value for erase and write is 6ohm.
s25fl256 flash ic
Here we discuss the JTAG on platforms. CPU,CPLD etc.
Jump to
- General
- ↳ News
- ↳ MISC
- ↳ Flash Type
- ↳ NVRAM requests.
- ↳ Device swap
- ↳ Device donation recognition.
- ↳ Android Tips and Trick
- ↳ Off the topic.
- ↳ USB JTAG/BDM software wish list.
- ↳ Bug report.
- ↳ Script Forum
- ↳ Videos.
- USBBDM (NT)
- ↳ Product Support.
- ↳ BDM (NT) on digital box.
- ↳ BDM (NT)on DCT 2224/2244
- ↳ Firmware issue.
- ↳ Newbie
- ↳ Nvram isues
- ↳ PPV issues.
- ↳ Hardware issue
- ↳ BDM (NT) on Star Choice
- ↳ DigiCipherII issue.
- ↳ BDM (NT)on Car Engine computer
- ↳ BDM spanish-section
- ↳ Knowledge base
- USBJTAG (NT)
- ↳ Product Support.
- ↳ Linux software issues.
- ↳ Devices
- ↳ JTAG (NT) on Cable Boxes
- ↳ JTAG on dct2500/dct700
- ↳ JTAG on DVI3000
- ↳ DCT64XX,DCT34XX
- ↳ JTAG ON DCH boxes
- ↳ USB JTAG (NT) on SurfBoard Modems
- ↳ JTAG (NT) Modem newbie
- ↳ SB5XXX
- ↳ SB4XXX
- ↳ WiFi modem
- ↳ SB6XXX
- ↳ Other modems
- ↳ JTAG on Dish Receivers.
- ↳ USB JTAG NT on XBOX
- ↳ USB JTAG (NT) on VOIP device.
- ↳ USB JTAG (NT) on other devices.
- ↳ Platforms
- ↳ JTAG to debrick
- ↳ USB JTAG (NT) for development.
- ↳ JTAG spanish-section
- ↳ JTAG (NT)for modem
- ↳ JTAG (NT) for cable box
- ↳ USBJTAG NT 中文
Who is online
Users browsing this forum: No registered users and 2 guests