3 posts • Page 1 of 1
- Junior Member
- Posts: 1
- Joined: Fri Jan 01, 2021 5:33 pm
I’m trying to clone SB6121. I did use Separate 3.3 V on pin 2. I did got the readout from the chip. But the problem is when I read the flash from the first modem and write the flash to the second modem the modem does not boot up and if I erase and rewrite the original information the modem boots up no problem. Same thing if I read the second modem and write the information to first modem the modem does not boot up. And I also have tried jumping the pin 1 pin 2 and pin 10. Same thing.
Users browsing this forum: No registered users and 1 guest