New forum created.

Use USB JTAG NT for development. GNU deugger etc.
Post Reply
usbbdm
Junior Member
Posts: 8730
Joined: Mon Jul 18, 2005 9:33 pm

New forum created.

Post by usbbdm »

This forum is for people use USB JTAG NT on development.
I am currently working on Microchip PIC32. I got starter kit from Microchip and hope will add the programming on it first. Latter will add GNU support for this board.
Please note there will be a lot of development work to put in and please allow time to add each development in.
boarder1042
Junior Member
Posts: 129
Joined: Fri Jan 18, 2008 7:18 pm

Post by boarder1042 »

GREAT NEWS!

I just got a dip/pic programmer the other day
usbbdm
Junior Member
Posts: 8730
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

The programming of PIC32 at slow speed is finished. There is a requirement to support Intel Hex file. I will add this. PIC32MX is a nice little toy.
boarder1042
Junior Member
Posts: 129
Joined: Fri Jan 18, 2008 7:18 pm

Post by boarder1042 »

What chips will it support?

12fxxx series?
usbbdm
Junior Member
Posts: 8730
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

The current board I had is PIC32MX from Microchip.
ricktendo
Junior Member
Posts: 134
Joined: Sat Nov 29, 2014 12:41 pm

Post by ricktendo »

What is the pinout for PIC32MX?
usbbdm
Junior Member
Posts: 8730
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

ricktendo wrote:What is the pinout for PIC32MX?
Depends on your board. Mine is dev board and it is standard MIPS EJTAG. This is the same pinout as USB JTAG NT.
ricktendo
Junior Member
Posts: 134
Joined: Sat Nov 29, 2014 12:41 pm

Post by ricktendo »

usbbdm wrote:Depends on your board. Mine is dev board and it is standard MIPS EJTAG. This is the same pinout as USB JTAG NT.
Its for a UniSolder board, here is the pinout used for the original pickit 3 flasher

Image

Image
usbbdm
Junior Member
Posts: 8730
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

That is not standard JTAG pinout. It must be PIC32 private interface.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest