vt2142 debrick

Use USB JTAG NT on VOIP device so we can unlock the device or configure the device.
Post Reply
stealthster
Junior Member
Posts: 5
Joined: Mon Oct 11, 2010 2:38 am

vt2142 debrick

Post by stealthster »

what are the debrick commands.
tried searching but couldnt find any info.
thank you.
usbbdm
Junior Member
Posts: 8962
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

stealthster wrote:what are the debrick commands.
tried searching but couldnt find any info.
thank you.
All brick commands are similar (EJTAG).
Enter DEBUG ON (tap c and tap a ffffffff)
Then detect the flash.
Use slow erase/program to program the boot.
Power off on and use fast programming to program the rest.
If you need help remotely, I might be able to do it in the evening.
stealthster
Junior Member
Posts: 5
Joined: Mon Oct 11, 2010 2:38 am

Post by stealthster »

thank you for quick reply
stealthster
Junior Member
Posts: 5
Joined: Mon Oct 11, 2010 2:38 am

Post by stealthster »

ok i was able to reprogram it.
and used all these commands
vt2142boot
vt2142log
erase cfg1
erase cfg2
program log
program boot
and am able to access the voice provisioning page
not sure if that was there before the programming? am i suposed to see the sip settings page?
and when is the VT2142 with SIP setting GUI (3.49 MB) file to be programed?

thank you for your help.
Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests