Hi people.
I have been trying to read a 1 wire (uniwire) eeprom and just can't get it to read
The chip is 11LC160.
I have exhausted all the parameters for a DIY XML.
I really would like support for this series of chip.
Just guessing the DLL does not support the correct protocol.
My device is a new J-LINK, and J-LINK v1.45 software.
I have the Microchip datasheet if that can help.
TYIA
boxnut.
Microchip 11AAxxx chip support.
-
- Junior Member
- Posts: 22
- Joined: Wed Feb 12, 2020 2:46 am
- Location: Northwest US
- Contact:
Microchip 11AAxxx chip support.
Some of my information may be incorrect, incomplete,or just plain wrong. Seems I am human.
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Re: Microchip 11AAxxx chip support.
I do not have the chip to test against. This is new protocol that needs developemnt.
-
- Junior Member
- Posts: 22
- Joined: Wed Feb 12, 2020 2:46 am
- Location: Northwest US
- Contact:
Re: Microchip 11AAxxx chip support.
I got that. Only 2 differences between this and the Dallas DS2431 is 2 to 5.5 volt vcc and 16K X 8 instead of 1K X 8
My setup will read the Dallas device but not the Microchip.
My goal is to replace the Dallas IC with the Microchip. adding VCC should be the only issue.
It will be middle of January before I can send you a smple, and can link the datasheet.
Thanks for your time.
boxnut.
My setup will read the Dallas device but not the Microchip.
My goal is to replace the Dallas IC with the Microchip. adding VCC should be the only issue.
It will be middle of January before I can send you a smple, and can link the datasheet.
Thanks for your time.
boxnut.
Some of my information may be incorrect, incomplete,or just plain wrong. Seems I am human.
Who is online
Users browsing this forum: No registered users and 4 guests