Routers, VOIP devices, etc.
2 posts • Page 1 of 1
- Junior Member
- Posts: 1
- Joined: Tue Jun 21, 2022 3:39 am
Hello, Is there support for these deivices? I have seen there is support for Arm9, but cannot find out much on the spansion memory. I have enclosed the data sheets for both. I have verified the jtag pinout on my device (an older model radio that I wish to revive). All i really need is to be able to write the entire flash. I already have a good back up. Was ready in my devices service manual that memory writes and reads need wait states and cycles, would this hold true for a blank memory chip? How would this be handled? When I hook up the Jtag It reads one IdCode (03CF1D81) manufacturer not found 6C0. Then Exit thumb mode next line error. I have verified all the pins on my ulink are good by jumpering like the youtube video. Any advice? I have included the data sheets for these devices.
Users browsing this forum: No registered users and 3 guests