Cisco EPC3208

JTAG (NT) on Cable Boxes

Moderator: justsomeguy

Post Reply
XonA
Junior Member
Posts: 5
Joined: Fri Mar 21, 2014 11:03 am

Cisco EPC3208

Post by XonA »

hello there!
I'm trying to change the firmware of Cisco EPC3208 which goes with success. But after i flash the UBFI1 and UBFI2, the bootloader wont start the firmware that I flash! Its BCM3382, i've tried some bootloaders but they wont work unless the bootloader is the original one!
The original bootloader, won't start the modded firmware. it flashes 4 lights and nothing happens. Can somebody help me out here a little bit :)?

Thank you!
Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests