Sbg1000 help

All WiFi Modems
Locked
nunny
Junior Member
Posts: 122
Joined: Mon Feb 05, 2007 7:33 pm
Contact:

Sbg1000 help

Post by nunny »

i have tried to change the firmware but for some reason you change it do a cmpram averything goes ok but the firmware stays the same 0.1.9.3 im using the sbg900 tabs and i program the firmware in the app tab another thing is that i havent been able to do program y have to use erase app and then sprogram app.

the cpu its a broadcom 3360 and the flash is an Intel 28F640J3 i had to add the cpu to the vendors list to get it working.
usbbdm
Junior Member
Posts: 8962
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

nunny wrote:i have tried to change the firmware but for some reason you change it do a cmpram averything goes ok but the firmware stays the same 0.1.9.3 im using the sbg900 tabs and i program the firmware in the app tab another thing is that i havent been able to do program y have to use erase app and then sprogram app.

the cpu its a broadcom 3360 and the flash is an Intel 28F640J3 i had to add the cpu to the vendors list to get it working.
There might be two copies of the firmware and you only change one of them.
nunny
Junior Member
Posts: 122
Joined: Mon Feb 05, 2007 7:33 pm
Contact:

Post by nunny »

i have cheked the Intel 28F640J3 and i think its 4MB did a 4mb backup and i only see one copy of the firmware using a hex editor.

i have some firmwares here and they are 3.15MB the las one that i tried is a .p7 what i did was remove the header to make it a bin flashed it to the modem and still the same it didnt change
usbbdm
Junior Member
Posts: 8962
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

This is *M flash ayou need to check memory map again.
hesantos83
Junior Member
Posts: 7
Joined: Fri Jan 26, 2007 5:41 pm
Location: JERSEY

Post by hesantos83 »

i'm trying to flash this modem with haxoware 1.1 rev31 since i dont care about the wifi on this modem but i'm getting this error:

Dest must start at the boundary of a block
i can detect the modem and backup original firmware this modem should work with haxoware 1.1 rev31. because it's like a webstar dcp2100r2 with the spantion flash.

IDCODE 0334917F
Broadcom BCM3349
IMPCODE 800904
DMA supoorted
Found Address= 9fc00000 Intel 28F640J3
usbbdm
Junior Member
Posts: 8962
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

As of programming your definition is not on the boundary of a sector of the flash. In fact I doubt it will work for you.
Locked

Who is online

Users browsing this forum: No registered users and 6 guests