?sb4220?

[jay209311]

hello all, any1 have any new info on a sb4220? i see it has a 14 pin connector. i have succesfully used a rs-232 serieal cale. here is a copy of the console dump. but i have had no luck jtagging this thing.


Power-On


Cable Modem Image starter
Texas Instruments (C) 2002
Version 02.00

Flash autodetection returned: 0x00000000
VendorID: 0x0089 DeviceID: 0x88C2

Select image to run: [1][2]
Running image #1.
Trying to run Default Image
Prefix address - B0010000 Found image CRC OK; Decompressing
..................................
Well, looks OK; Let's go
Target Name: vxTarget
Attached TCP/IP interface to emac unit 0
NFS client support not included.
0x947ffdf0 (tRootTask): Loading RNDIS End Driver...
0x947ffdf0 (tRootTask): Memory setup complete
0x947ffdf0 (tRootTask): Configuring rndis2...
0x947ffdf0 (tRootTask): Done loading RNDIS END.

SB4220: MIPS Core speed is 125.00 MHz (100 Ticks per second)
Installed MIPS exception handler
Initialized BBIF








****
****
******o***
********_///_****
******/_//_/*****
** ***(__|*****
*********
****
***



***********************************
** Texas Instruments ***
** DOCSIS based Cable Modem ***
***********************************


Version 6.3.3 (Build 20_08_02:1) - Creation Date/Time: Nov 26 2002 / 09:45:01


Initializing FLASH driver returned 0
USB_Init
0x947ffdf0 (tRootTask): After USB_Init


CONSOLE-CLI was disabled at compile-time.

InitCB
init RNDIS CB
Attaching network interface lo0... done.