ecu flash Am29BL802CB (Am29BL802CB-65RZE)
-
- Junior Member
- Posts: 22
- Joined: Mon May 09, 2022 11:19 am
ecu flash Am29BL802CB (Am29BL802CB-65RZE)
I don't suppose USBJTAG can read this style off flash chip off board can it?
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Re: ecu flash Am29BL802CB (Am29BL802CB-65RZE)
Depends on what type of CPU it has. Read is possible,write needs to see if work needs to be done. Chat with me via online chat when you see me online.
-
- Junior Member
- Posts: 22
- Joined: Mon May 09, 2022 11:19 am
Re: ecu flash Am29BL802CB (Am29BL802CB-65RZE)
Hi
In this instance the ecu has been fired. The eeprom was able to be retrieved but the ecu is dead the ecu carries an mpc556LF processor. So I was looking for a solution to read the flash independently without removing it from the board. For instance going direct pin soldering
The ecu is from a mazda bt50 2011 ecu type is edc16c7
Regards
In this instance the ecu has been fired. The eeprom was able to be retrieved but the ecu is dead the ecu carries an mpc556LF processor. So I was looking for a solution to read the flash independently without removing it from the board. For instance going direct pin soldering
The ecu is from a mazda bt50 2011 ecu type is edc16c7
Regards
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Re: ecu flash Am29BL802CB (Am29BL802CB-65RZE)
I have only played on EDC16 and people tried their EDC16 and said it is not working for them. I just need to modify software to work with the EDC. In general u-link NT does support MPC5xx CPU.
-
- Junior Member
- Posts: 22
- Joined: Mon May 09, 2022 11:19 am
Re: ecu flash Am29BL802CB (Am29BL802CB-65RZE)
Would there be a pin out avaliable ? So I can attempt if it works?
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Re: ecu flash Am29BL802CB (Am29BL802CB-65RZE)
Pinout on u-link NT side is in the software. On the ECU side, you need to find out yourself.
-
- Junior Member
- Posts: 1
- Joined: Thu Mar 02, 2023 4:21 pm
- Location: US
- Contact:
Re: ecu flash Am29BL802CB (Am29BL802CB-65RZE)
It uses a regular bosch style bdm. You can match pinout with ulink by matching up GND pin but top left pin you see in photo is "pin 1".tomanycars wrote: ↑Sun May 14, 2023 10:36 pmWould there be a pin out avaliable ? So I can attempt if it works?
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Who is online
Users browsing this forum: No registered users and 3 guests