so I've been writing to the SBV6220 for a good while now and all of a sudden, each time i write to the modem, it's bricked!! (all lights on after a successful write/verify). what's going on... I've written to this SPI chip 100's of times and now it will not boot. i had a second SBV6220 as backup laying around so i wrote an original 16M to that and same issue. this started to happen about 2 days ago and im all out of ideas as to what the problem is. i develop my own firmware so im constantly writing to the chip. i use the ISP pin method primarily and tried the external 5V method and both write/verify successfully but the modem will not boot up. (stuck with all lights on)
it's as if the jtag's telling me it's writing in one spot and writing somewhere else because
if it were writing where it should, the device would boot up as it should. I'm running 0.77 jtag software. i've tried writing at all speeds and same thing. and yes it detects the chip correctly.
any help is greatly appreciated.
thanks
Hybrid Brick (possible jtag bug)
-
- Junior Member
- Posts: 3
- Joined: Tue May 03, 2016 11:19 am
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Who is online
Users browsing this forum: No registered users and 2 guests