DP311

JTAG on Dish Receivers.
pasor
Junior Member
Posts: 129
Joined: Fri Dec 19, 2008 7:35 am

Post by pasor »

marthypaul wrote:Dish will never replace all receivers to meg4. There is plenty of international channels and they stay in mpg2 for a long time.

There is method to partially disassemble some "key" in receivers with processor 7xxx, and that would enable IKS in NA.

And it is impossible yet with processors different than 7xxx.
So with "equipment pairing" introduced with new receivers, IKS is gonna be shut down for all mpg4 channels.
You still will be able to get those international channels with meg4 receivers. Receivers like 301,311,322,501,522 will be obsoleted, also Iks will be difficult since they will try to mirror everything to eastern arc.
Pichardo
Junior Member
Posts: 79
Joined: Tue Jun 17, 2008 11:19 pm

DP311 jtag pinout, please

Post by Pichardo »

Anybody have the correct pin out for this receiver DP311 ?

Some picture help a lot . . .

In the device support i read that's this receiver is now supported "Protocol = ST20C1".


Keep Trying . . . !
Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests