Found Address= 7fc00000 CFI ST 29W320DT
-detect
IDCODE 1D405041
STi STi5518
Unknown flash type!
Report these values http://www.usbjtag.com/vbforum 0000,0000
Unknow flash
-
- Junior Member
- Posts: 8974
- Joined: Mon Jul 18, 2005 9:33 pm
What target you select?JTog wrote:Found Address= 7fc00000 CFI ST 29W320DT
-detect
IDCODE 1D405041
STi STi5518
Unknown flash type!
Report these values http://www.usbjtag.com/vbforum 0000,0000
-
- Junior Member
- Posts: 5011
- Joined: Sat Dec 27, 2008 3:25 pm
What version of software are you Using? You should be Using 0.56a.JTog wrote:The program require disconnect USB cable almost after each command, perhaps you could add toggling S_RST signal to the model ? The signal should go to pin#17 on DCU 20 pin connector.
"If you give a man a fish you feed him for a day. If you teach a man to fish you feed him for a lifetime."
-
- Junior Member
- Posts: 8974
- Joined: Mon Jul 18, 2005 9:33 pm
I have tested DCU and 301-13.1 long time ago and it used to work fine and fast. I have not played with it for a while and not sure if there is a bug in it. When I have time I might test it again.JTog wrote:DCU and 301-13.1
I might get a remote session with you to see why it disconnected each time. Here is a video showing DCU3 support.
Who is online
Users browsing this forum: No registered users and 11 guests