dead box? bricked? Help!

[ttoken]

I tried to reflash the code and it when I do the flashdct it doesnt recognize the flash. The box doesn't even power up and BDM never comes on.

Anyway to revive this?


Here is the script that I ran, but nothing:



-debrick
// This script is to debrick a DCT2000
-reset 1
-init
// These are is most important lines !!
-r a7 200400
-r rpc 468
// Load your backup code
-ldram code
// detect flash
-flshdct code

Unknown flash type!
Report these two value to [email protected] 0003,0003
// This will take about 1 minute.
-program code
No flash type found, call "flshdct"

[usbbdm]

Check your BDM connection to make sure pin 1 matches. Also if your BOX is PH6 or CR4, make sure you have disabled the watchdog.

[ttoken]

I have a PH8.



If I flip the connection it gives me this error and BDM still does not come on:

Unknown flash type!
Report these two value to [email protected] ffff,ffff

[usbbdm]

After reset 1 you MUST see BDM ON. Otherwise, something is wrong and you cannot fix it.