Sprogram vs Program

This is JTAG to debrick any JTAG device. Modem, cable boxes, dish boxes routers.
Post Reply
Junior Member
Posts: 68
Joined: Fri Oct 13, 2006 12:16 pm

Sprogram vs Program

Post by softrend »

I can erase and sprogram all tabs, but the modem light are off, when I intent execute program command, erase starts... and don´t make anything.

IDCODE 0334817F
Broadcom BCM3348
IMPCODE 00800908
EJTAG V1, V2.0
DMA supoorted
Found Address= 9fc00000 MX29LV161B
Junior Member
Posts: 8714
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

sprogram is used when the modem is bricked. You only need to do it to the boot.
After program you need to compare the result to confirm the data was written correctly.
Program finished does not mean programmed correct. Especially for sprogram using DMA.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest