stx5100 cannot get TRAP ON

JTAG on Dish Receivers.
Post Reply
jekkos
Junior Member
Posts: 14
Joined: Wed Apr 04, 2012 5:15 am

stx5100 cannot get TRAP ON

Post by jekkos »

dear,

Currently I'm trying to connect to a dcu3 target (stx5100JUib)
however I cannot get trap on.

I connected TRST but not RST (can this be an isuse?)

I already added the flash config for the device
this should be ST M28W160CB
http://pdf.datasheetcatalog.com/datashe ... s/7358.pdf

found a similar entry for this one and adapted the device id (just one hex character)

also I found the RAM chip to be the following HY5DU121622BT-J (512Mb)
http://pdf.datasheetcatalog.com/datashe ... zskrwy.pdf

what value should i used for this total in hex? What is the formula to convert Mbits to hex totals?

I added this to vender.xml

<Part>
<Name>STx5100</Name>
<Id>0xD423</Id>
</Part>

Probably the ram memory range is incorrect so the cpu can't be trapped? Do I need to connect the RST pin as well or is TRST sufficient? Can anyone find a datasheet fro STx5100? I can only find a brief product description

Maybe I need to find memory map to see at which address I should load the overlay?

Could you give me some assistance on this (maybe TeamViewer with usbbdm?)

Image

thanks.
usbbdm
Junior Member
Posts: 8962
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

So your chip is Stx5100? I googled and could not find useful info. Are you sure this is DCU3? If it does not work with the existing 3300 (see TRAP ON), then you need to get the datasheet and hopefully this is a simple DCUReg change. Without those info, teamview will not help much.
usbbdm
Junior Member
Posts: 8962
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

Try to see 0x30003000 to see if it works. This is just a guess.
jekkos
Junior Member
Posts: 14
Joined: Wed Apr 04, 2012 5:15 am

Post by jekkos »

ok will try that address. Found one datasheet that mentions stx5100 as ST20 243Mhz. However no mentioning of DCU3.

when do you know a box is DCU3?

http://www.datasheetarchive.com/dl/Data ... 293786.pdf

Will try to change register address. Maybe I can have more luck with st toolset..
jekkos
Junior Member
Posts: 14
Joined: Wed Apr 04, 2012 5:15 am

Post by jekkos »

I suppose it's juts st20. Using extremeview 3300 I get following response

-detect
IDCODE 2D423041
STi STx5100
Unknown flash type!
Report these values http://www.usbjtag.com/vbforum ffff,ffff

but no trap on. any idea why the flash query does show up? I thought this could only be done using trap on?
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests