Usbjagnet

pasor · Post by **pasor** » Sun Nov 17, 2013 11:21 am

I am trying to write cfg to 5101 and I am getting the following message at left corner of usb jtag application : Dest must start at boundary of a block.

Post by **usbbdm** » Sun Nov 17, 2013 11:30 am

pasor wrote:I am trying to write cfg to 5101 and I am getting the following message at left corner of usb jtag application : Dest must start at boundary of a block.

What target did you select?
What it says it that the place you are trying to program is not at the boundary of the a sector.
If not it will erase part of the block and your modem will be bricked.

pasor · Post by **pasor** » Sun Nov 17, 2013 7:18 pm

usbbdm wrote:What target did you select?
What it says it that the place you are trying to program is not at the boundary of the a sector.
If not it will erase part of the block and your modem will be bricked.

I did selected the right target cfg, it did happen before to me but when I updated to new jtag software version it stopped doing, now is doing again.

Post by **usbbdm** » Sun Nov 17, 2013 8:36 pm

pasor wrote:I did selected the right target cfg, it did happen before to me but when I updated to new jtag software version it stopped doing, now is doing again.

This is not in software. It is in the xml for your target.

pasor · Post by **pasor** » Mon Nov 18, 2013 7:27 pm

usbbdm wrote:This is not in software. It is in the xml for your target.

How do I get this issue fixed.

Post by **usbbdm** » Mon Nov 18, 2013 8:24 pm

pasor wrote:How do I get this issue fixed.

You need to show the problem first before I can decide if it is a problem or not.
IF you think one version works then copy the XML from that version will fix the "issue".

USB JTAG

Usbjagnet

Usbjagnet

Who is online