Page 1 of 2

Youtube video introducing u-Link NT.

Posted: Mon Jan 13, 2020 6:37 pm
by usbbdm

u-Link NT Program MR 16 (MIPS EJTAG)

Posted: Tue Jan 14, 2020 7:11 pm
by usbbdm

The speed is slower when I am recording using OBS Stdio. I used use another program but video quality is not as good.

u-Link NT program SB6121 and SB6141 modem.

Posted: Wed Jan 15, 2020 8:00 pm
by usbbdm

Using 3.3v direct from u-Link NT is enough to power these two modems.

u-Link NT program SB5101 and SB5120 modem

Posted: Thu Jan 16, 2020 6:12 pm
by usbbdm

u-Link program DCT700

Posted: Fri Jan 17, 2020 6:26 pm
by usbbdm

u-Link NT program DVG-1120(MPC850)

Posted: Sun Jan 26, 2020 10:18 pm
by usbbdm

u-Link NT program XBOX 360.

Posted: Wed Jan 29, 2020 9:58 pm
by usbbdm

u-Link NT program Atmega chip.

Posted: Wed Jan 29, 2020 11:00 pm
by usbbdm

USB JTAG NT cannot program Atmega chip because the clock speed as well as some special initialization cannot be done with USB JTAG NT hardware.
u-Link can have much slower clock speed and each pin can be programmed.
If you need to use this tool on production line, you can program 16 Atmega chips at the same time.

u-Link NT as JTAG pin finder.

Posted: Sat Feb 01, 2020 9:10 pm
by usbbdm

u-Link NT program ST40 core.(Sti5202)

Posted: Sun Feb 02, 2020 5:05 pm
by usbbdm

u-Link NT program ST20 target.

Posted: Mon Feb 03, 2020 9:49 pm
by usbbdm

u-Link NT program DM500S

Posted: Tue Feb 04, 2020 10:54 pm
by usbbdm

u-Link NT program EEPROM

Posted: Thu Feb 06, 2020 10:17 pm
by usbbdm

u-Link NT program Nano Premium (ARM946)

Posted: Fri Feb 07, 2020 9:55 pm
by usbbdm

u-Link NT program Altera CPLD.

Posted: Sat Feb 08, 2020 8:18 pm
by usbbdm